Herbicide Activator, Spreader, Activator, Penetrant is a blend of nonionic surfactant and oil formulated to give fast wetting and improved foliage penetration without causing premature desiccation. There will be no excessive foaming created in the spray mixtures and no corrosive effect in equipment. This product may be used on agricultural, forestry, turf and ornamental, industrial and non-cropland sites.
Herbicide Activator is most beneficial and is compatible with most types of herbicides, defoliants and desiccants. However, if the desired combination has not been previously used, a compatibility test is recommended. Avoid use with selective herbicides where the selectivity depends on not wetting the primary crop.
Herbicide Activator Mixing: Shake well before using. Fill spray tank ½ full of water and begin agitation. Add the recommended amount of Brandt Herbicide Activator. Add products as directed by label or in the following sequence and continue filling tank: (1) Dry flowables or water dispersing granules, (2) Wettable powders, (3) Flowables, (4) Solutions, (5) Emulsifiable concentrates. Continue agitation until spray solution is completely mixed. Continuous agitation of finished spray is recommended. If spray solution has been allowed to stand, thoroughly agitate and remix before application.